Skip to content
English - United States
  • There are no suggestions because the search field is empty.

How to Program a Replacement GM Module With SPS2 in Techline Connect: Reprogram vs Replace and ReprogramWhat question is your article answering?

Connect the interface, open SPS2 in Techline Connect, choose Reprogram or Replace and Reprogram, and finish with the post-programming steps.

What You Need to Program a GM Module 

Programming a GM module with Techline Connect (formerly TIS2Web) needs an ACDelco TDS account at acdelcotds.com, an SPS2 subscription for the VIN, a compatible interface, and a Windows 11 PC with local administrator rights. Use a wired USB connection. If you do not have an account, see the article on creating a new ACDelco TDS account.

For the interface, a GM MDI 2 works across GM vehicles. An approved J2534 pass-thru can be used on older vehicles, but newer GM vehicles (Global B / VIP) need the MDI 2. See the GM diagnostic interface guide for the platform list. Connect a 12V battery maintainer to the GM vehicle so voltage does not drop during programming.

Install and Launch GM Techline Connect 

Download the Techline Connect installer from your ACDelco TDS account after adding the VIN. Right-click the installer and choose Run as administrator, and let the initial downloads and updates finish. If updates or connections stall, temporarily pause antivirus or firewall blocks. Log in to ACDelco TDS, select the VIN, and launch Techline Connect from the portal. For the full install, see the Techline Connect setup article. 

Program the GM Module in SPS2 

  1. Plug the interface into the vehicle’s OBD-II port and turn the ignition on (or service/accessory mode if required).

  2. Confirm Techline Connect detects the interface and reads the VIN correctly.

  3. Open SPS2 (Service Programming System 2) from the side menu.

  4. Choose Reprogram for an existing module, or Replace and Reprogram for a replacement module.

  5. Select the target controller (for example the ECM, TCM, radio, or the VTD/immobilizer) and check the calibration and RPO selections.

  6. Start programming. Do not disconnect cables or cycle power until it finishes.

Used Modules on GM Vehicles 

On Global A vehicles (2014 and newer GM), a used or donor module will not function. Use a new module.

After Programming a GM Module 

Turn the ignition off for 30 seconds, clear DTCs, and run any required relearns or immobilizer routines. For the VTD routine and its 30-minute security wait, see the GM key programming procedure article. 

If GM Programming Fails 

See the articles GM Module Programming Fails Through SPS2 / Techline Connect: Where to Start and Techline Connect Error Codes E4399 / UEH101. For help, contact AETools at https://aetools.us or call (913) 856-6678.